Masterad Processing Aid AD-351L contains a latest generation fluoroelastomer dispersed in LLDPE carrier. Physical Form Colorless, translucent pellets. Applications Masterad Processing Aid AD-351L is recommended for the elimination of melt fracture during production of LLDPE and HDPE blown film. The product’s lubricating effect provides the following benefits: -Production of film with higher surface gloss -Prevention of undesirable ‘orange peel’ effect -Improvement of processability and higher extrusion speeds. -Reduction of melt pressure and of power requirements. Instructions for Use Addition levels 1-2,5% depending on film thickness. Before processing of pure LLDPE or blends of LLDPE/LDPE with a high amount of LLDPE, it is recommended to run the clean extruder for 10-15 minutes at low speed with a mixture of 15% AD-351L and 85% LLDPE. Once the melt fracture has been eliminated, film production can continue with the recommended normal addition level of AD-351L. The protective lubricating coating can be destroyed by the presence of abrasive powders, such as TiO2 or SiO2. In such cases, a higher addition level is necessary. Masterad Processing Aid AD-351L may be negatively affected by the presence of antistatic additives, such as ethoxylated amines. Packaging In 25kg neutral bags on 1000kg shrink wrapped pallets. Storage Masterad Processing Aid AD-351L has a storage life of 12 months when stored in dry conditions away from direct sunlight and heat. The data and information herein are given as a guide. Petromall.co undertakes no responsibility either for result deriving from their adoption or for possible use for various applications.